INPRO / SEAL COMPANY

Inpro/Seal Company was established in 1965 as Inpro, Inc., a Worthington and Viking Pump Distributor. Even then, President and CEO David C. Orlowski understood that the sealing capabilities of rubber lip seals were grossly inadequate; a better bearing protection solution was required. In 1976, Orlowski was given the opportunity to initiate an ambitious program. Orlowski had recently begun to experiment with labyrinth seals, and when Grain Processing in Muscatine, Iowa, called seeking an answer to the extensive water contamination plaguing their pump bearings, Inpro fitted their pumps with newly developed Inpro/Seal Bearing Isolators. GPC remains to this day a faithful customer.
Over the past 25 years, Inpro/Seal Company has dedicated itself to constant improvement and refinement of our products and our practices. For instance, the headquarters in Rock Island houses a Research and Experimentation Lab, where Isolators are perfected, competitors' products are tested and new Inpro/Seal products are developed.

The Inpro/Seal Bearing Isolator is the industry standard for bearing isolation. In fact, the Inpro/Seal is standard equipment on IEEE-841 motors manufactured by Baldor, General Electric, Lincoln Electric, Marathon, Reliance Electric, Siemens, Toshiba and US Motors-Emerson--all of the major motor manufacturers in the United States, Taiwan, Korea, Canada and Mexico. Inpro/Seals are standard as well on ANSI pumps manufactured by the Durco and Peerless, and on Slurry Pumps by GIW. Same-Day Shipments are available, when required.

[Back to Pump & Seal]